Dish Network Dish 322 User's Guide download pdf (Page 8)

Page 5

Figure 3. Attaching DISH Pro Plus Twin with Screws

Install the satellite receiver(s) using the user's guide that came with your receiver(s).

Direct connect the RG-6 coaxial cable from the LNBF’s

PORT 1 to a peaking meter.

Peak the dish for the strongest possible signal on the 119W satellite signal.

Connect the cable from LNBF

PORT 1 to the satellite receiver’s SATELLITE IN connection(s)

referring to Table 2 on page 3.

a. If you are installing a single cable installation with a DISH Pro Plus Separator to a

DISH Pro Plus dual-tuner receiver, install a DISH Pro Plus Separator as follows (see

Figure 14 on page 17):

1) Connect a cable from the DISH Pro Plus Twin LNBF output (Port 1 or Port 2) to

the DISH Pro Plus Separator Input.

2) Connect cables between the receiver

SATELLITE IN 1 and SATELLITE IN 2 to PORTS

and 2 respectively on the DISH Pro Plus Separator.

You must use a DISH Pro Plus Separator in this installation. A splitter or other

devices will not work in this configuration.

b. If you are installing a Legacy receiver in this step, you must have a second satellite

receiver powered on and connected to

PORT 2 of the LNBF to complete this

installation.

Plug in and turn on the satellite receiver and TV. The

Point Dish/Signal screen should be

displayed - if not, you can open this screen on most receivers by pressing MENU on the

remote and selecting

System Setup, Installation, then Point Dish/Signal (refer to your

receivers user’s guide).

Select

Check Switch or Switch and then select either Check or Test to run Check Switch.

When the

Check Switch procedure finishes, you should see an Installation Summary screen

similar to one of those shown in Figures 4 and 5 on the next page.

• The summary screen shown in Figure 4 is similar to what should be shown for DISH Pro

and DISH Pro Plus receivers connected to the DISH Pro Plus Twin LNBF. Make sure the

summary screen shows reception from both 110W and 119W satellites on all available

satellite tuners. If not, consult your receiver user's guide to re-peak your DISH 500 as

needed. Also confirm the LNBF is correctly identified as a

DPP Twin (some early factory

software on some models may identify this LNBF as a

DP Twin. This identification is

OK).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 24 25

Comments to this Manuals

No comments

Dish Network Dish 322 User's Guide Page 8

Comments to this Manuals

Related products and manuals for Satellite antennas Dish Network Dish 322