Dish Network Dish 322 User's Guide Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 25
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
Page 19
When you run Check Switch, you see “DPP Twin” identified as the device or LNBF but you have signal
confirmed from only one satellite.
When you run Check Switch, 119W/110W satellites are detected but the third satellite from the connected
second dish is not detected.
When you run Check Switch, you do not see “DPP Twin” identified as a device or LNBF but odd
transponders are detected only on one satellite.
Possible Reason What to Do
The DISH Pro Plus Twin LNBF is connected but the dish
may not be pointed to receive signal from both 110W and
119W satellites.
If the Check Switch Summary Screen shows “119W” on
Dish Input 2, you need to point your dish 9 degrees to the
east and repoint it for the strongest possible signal.
If the Check Switch Summary Screen shows “110W” on
Dish Input 1, you need to point the dish 9 degrees to the
west and repoint it for the strongest possible signal.
Make sure the skew setting is correct for a DISH 500
installation at your Zip Code.
Run Check Switch.
Possible Reason What to Do
Cable to the second dish is disconnected. Check all the connections in your system and run Check
Switch again.
The third satellite is from a DISH Network bandstacked
FSS LNBF. Some older Legacy receivers cannot receive
programming from DISH Network bandstacked FSS
LNBF orbital locations.
A newer receiver model is required.
Two Legacy receivers are connected to the DISH Pro Plus
Twin LNBF and the LNBF cannot support the third
satellite. These receivers do not provide enough power to
support the
LNB IN port on the LNBF.
Replace one Legacy receiver with a DISH Pro or DISH
Pro Plus receiver.
Possible Reason What to Do
Your receiver may need a software upgrade. Refer to these instructions for information on taking a
software upgrade.
You may have a Legacy or DISH Pro switch or Legacy
LNBF in the system.
Remove any Legacy or DISH Pro switches or Legacy
LNBFs. Run Check Switch.
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25

Comments to this Manuals

No comments