Dish Network Dish 322 User's Guide download pdf (Page 13)

Page 10

Exit the

Point Dish/Signal screen and follow your receiver user's guide instructions for taking

a receiver software upgrade.

If exiting the

Point Dish/Signal screen does not start the upgrade process as described in the

receiver user's guide, then, turn off the receiver for at least 20 minutes to allow the receiver to

take a software upgrade.

After the receiver has completed taking the software upgrade, go to the

Point Dish/Signal

screen. With most receivers, you can do this by pressing MENU on the remote and selecting

System Setup, Installation, then Point Dish/Signal (refer to your receiver user’s guide).

Make sure the signal strength bar is green and locked.

Remove the DISH Pro compliant splitter. Either connect both receiver

SATELLITE IN

connections to LNBF

PORT 1 and 2 or install a DISH Pro Plus Separator (Figure 14 on

page 17) as follows:

a. Connect a cable from the DISH Pro Plus Twin LNBF output (

PORT 1 or PORT 2) to

the DISH Pro Plus Separator

INPUT.

b. Connect cables between the receiver

SATELLITE IN 1 and SATELLITE IN 2 to PORTS 1

and

2 respectively on the DISH Pro Plus Separator.

Select

Check Switch or Switch and then select either Check or Test to run Check Switch.

When the

Check Switch procedure finishes, you should see an Installation Summary screen

similar to Figure 7 below. Make sure the summary screen shows reception from both 110W

and 119W satellites on both satellite tuners. If not, consult your receiver user's guide to re-

peak your DISH 500 as needed. Also confirm the LNBF is correctly identified as a

DPP Twin.

Figure 7. DISH Pro Plus Installation Summary

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 24 25

No comments

Dish Network Dish 322 User's Guide Page 13