Dish Network Dish 322 User's Guide Page 1

EchoStar Technologies Corporation 136223 136223 TECHNICAL INFORMATION BULLETIN Subject: DISH Pro Plus Twin LNBF Installation Information & Spe

Page 7 Figure 6. Installing the DISH Pro Plus Twin LNBF with Upgraded Software

Page 8 Installing with any Dual-Tuner ReceiverThese instructions describe how to install the DISH Pro Plus Twin LNBF on a DISH 500 antenna with any du

Page 9 - If you are connecting a Legacy receiver (no DISH Pro or DISH Pro Plus label), RG-6 cable length must be 150 feet or less to the DISH Pro Plus

Page 10 Exit the Point Dish/Signal screen and follow your receiver user's guide instructions for taking a receiver software upgrade. If exiting t

Page 11 Figure 8. Installing the DISH Pro Plus Twin LNBF on any DISH Network Receiver

Page 12 Installing a Second ReceiverInstall another receiver to the DISH Pro Plus Twin LNBF completing one of the following:• For single-tuner receive

Page 13 Select Check Switch or Switch and then select either Check or Test to run Check Switch.When the Check Switch procedure finishes, you should se

Page 14 Figure 11. Connecting a Second Satellite Dish

Page 15 Connecting to a SwitchThe DISH Pro Plus Twin LNBF can be connected to a DISH Pro Plus 44 switch to provide 119W and 110W satellite signals to

Page 16 Wiring DiagramsFigure 13. Cable Length LimitationsExample: If you have a Legacy receiver attached 150 feet from a DISH Pro Plus Twin and a Sin

DISH Pro Plus Twin LNBFInstallation Instructions

Page 17 Figure 14. DISH Pro Plus Twin LNBF, DISH Pro Plus Separator, and a DISH Pro Plus ReceiverFigure 15. DISH Pro Plus Twin LNBF, DISH Pro LNBF, On

Page 18 Troubleshooting TablesWhen you run Check Switch, you do not see “DPP Twin” identified as a device or LNBF on a DISH Pro Plus or DISH Pro recei

Page 19 When you run Check Switch, you see “DPP Twin” identified as the device or LNBF but you have signal confirmed from only one satellite. When you

Page 20 Radio InterferenceThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. this device may

Page 21 Copyright NoticeCopyright © 2004 EchoStar Technologies Corporation, Englewood, Colorado 80112. All rights reserved.The information in these In

Attention and Warning SymbolsYou must be aware of safety when you install and use this system. This guide provides various procedures. If you do some

Page 1 ContentsIntroduction...2Installing with Singl

Page 2 IntroductionThe DISH Pro Plus Twin LNBF features DISH Pro Plus Technology and provides reception from the 110 and 119 orbital locations. The de

Page 3 Installing with Single-Tuner Receivers and Software-Upgraded Dual-Tuner ReceiversThe following instructions describe how to install the DISH Pr

Page 4 Cable Limitations• Only RG-6 coaxial cables rated for 950 to 2150 MHz can be used in this installation. Do not use existing cables such as RG-5

Page 5 Figure 3. Attaching DISH Pro Plus Twin with ScrewsInstall the satellite receiver(s) using the user's guide that came with your receiver(s)

Page 6 Figure 4. DISH Pro Plus Installation Summary• The summary screen below is similar to what should be shown for a Legacy receiver connected to th