Dish Network REMOTE CONTROL 6.0 Instruction Manual download pdf (Page 26)

Remote Controls - Remote Control Programming 13 - 26

Recover or

The customer uses Recover to restore satellite TV if they accidentally change the TV channel or video input. The remote

control must be programmed to operate the TV (and if used in-line, the VCR). The steps below describe how to use

Recover and how to program the RECOVER button on Remote Control 2 for TV2. You can also program RECOVER for a

connected VCR using the same procedure (use VCR or DVD mode instead of TV mode).

Using RECOVER

1. Make sure the TV is on.

2. Press and hold RECOVER until all four mode buttons light up, then release. The SAT mode button ashes twice and

then all four mode buttons ash three times.

3. Press RECOVER. Wait for the TV, VCR, or DVD mode button to ash once and then all four mode buttons to ash once.

4. If you see the System Information screen, press SELECT to close the screen. You have recovered your satellite video.

5. If you do not see the System Information screen, repeat steps 3 and 4 until you do.

Programming RECOVER for Remote Control 2

1. Program Remote Control 2 to control your TV.

2. Press and hold the TV mode button until all mode buttons light up.

3. Press STAR (*).

4. Enter your TV2 Agile channel using 3 digits (for example, 0-6-0 for Channel 60).

5. Press POUND (#).

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 63 64

No comments

Dish Network REMOTE CONTROL 6.0 Instruction Manual Page 26