Dish Network REMOTE CONTROL 6.0 Instruction Manual download pdf (Page 23)

Remote Controls - Remote Control Programming 13 - 23

Remote Control Programming

The programming instructions included in this section are for the following remote control versions: 3.0, 3.1, 3.2, 4.0,

5.0, 5.2, 5.3, 6.0, 6.2, 6.3, 6.4, 8.0, 8.1, 10.1, 20.0, and 21.0. While these instructions work for the 20.0, and 21.0 remote

controls, there may be even easier options.

Changing the Remote Control Address

1. Press SYSTEM INFO on the receiver’s front panel (or turn the receiver off and press CHANNEL UP). The System

Information screen displays. Notice the current Remote Address.

2. Press and hold the SAT mode button until all mode buttons light up, then release.

3. Use the NUMBER PAD to enter any number between 1 and 16, but not the one you saw in step 1.

4. Press POUND (#). If you entered the address correctly, SAT will ash three times.

5. Press RECORD. Make sure the Remote Address you see on the System Information screen is the same as the one

you entered in step 3. If it isn’t, the remote cannot control the receiver.

6. Press SELECT to close the System Information screen.

Reading Back the Codes

The following steps will help you determine the code programmed into a remote. If you need to replace the remote

control, use these steps to nd out the codes for your new remote. Our example is for the TV, but VCR/DVD and AUX can

also be read back; see step 3 for details about the AUX mode code.

1. Press and hold the TV mode button until all mode buttons light up, then release.

2. Press POUND (#) two times.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 63 64

No comments

Dish Network REMOTE CONTROL 6.0 Instruction Manual Page 23