1
Conguring the 3.4 Remote
Conguring the 4.4 Remote
The 3.4 remote does not require any
conguration. Go to Insert the Batteries (page 2).
1
2
3
4
Decide if the remote is being used
for TV1 or TV2. If it is being used
for TV1, determine whether to use
IR or UHF signals for the remote.
Use UHF signals if you do not
have a clear line of sight between
the remote and the receiver.
Pull the remote battery cover off.
If your remote shows a “1” or a “2”
on the bottom, you can pull out this
key and ip it to the other number
(2 to 1 and 1 to 2). To separate the
key from the remote, insert your
thumbnail or a coin in the crease.
Remove the key by grasping at the
bottom.
Insert the key you wish to use to
designate the remote and slide
into place. Usually a 1 = TV1 and a
2 = TV2. Use the green 1 (no UHF
Pro markings) for TV1 IR. Use the
green 1 UHF Pro for TV1 UHF.
Continue to
Insert the Batteries on page 2.
Complete the following
steps to congure
your remote.
SIZE "AAA"
AAA
AAA
AAA
AAA
UHFUHF
PRO
UHFUHF
PRO
UHFUHF
PRO
Comments to this Manuals