Dish-network DISH 351 User Manual

Page 9Chapter 2Receiver Description and InstallationThe Receiver Front PanelSmart Card DoorBehind this door is a slot for a future smart card. No smar

Page 18Chapter 2Receiver Description and InstallationNote: If the Results menu displays No Transponders have been found, check your cable connections

Page 19Connecting Your Receiver to a Phone LineConnecting Your Receiver to a Phone LineYou must keep your receiver connected to an active telephone li

Page 20Chapter 2Receiver Description and InstallationNote: Usually, you need a telephone number prefix only for business installations. For most resid

Page 10Chapter 2Receiver Description and InstallationThe Receiver Back Panel ConnectionsTighten the connections by hand only. If you use a wrench you

Page 11Remote ControlTelephone JackConnect a telephone cable with a standard RJ-11 telephone connector to the receiver here, and then connect the cabl

Page 12Chapter 2Receiver Description and InstallationRemote Control BatteriesThe remote control comes with AAA batteries, which need to be installed w

Page 13Remote Control SettingsRemote Control SettingsChange the AddressThe remote control and receiver can operate on any one of 16 addresses; however

Page 14Chapter 2Receiver Description and InstallationConnecting Your Receiver Connection Diagram ExampleThe diagram below is an example of how to conn

Page 15Performing the QAM Frequency ScanPerforming the QAM Frequency ScanNote: When you turn your receiver on it may display the QAM Frequency Scan an

Page 16Chapter 2Receiver Description and Installation3. Select the Installation option on the System Setup Menu. The Installation and Setup Menu scree

Page 17Performing the QAM Frequency Scan5. Select the Scan option.While scanning, the receiver displays the QAM Frequency Scan Progress screen. The sc